is there a way we can be able to release the DIMENSION when we create a progress bar? because usually the minute we create a progress bar, the DIMENSION becomes locked and I cannot be able to flatten the progress bar to the extreme.
I know you can control that by bigger curving, but still, I don’t wanna a bigger circle , just a small size progress bar and more flat, which means small curving.
Thank you
Are you asking about when you create the component progress bar or when you add a complication with a ranged value type?
in both cases there is a thickness setting for the progress bar
Ron
Samsung Developer Relations
thnx for the reply.
it has nothing to do with thickness. you understood me wrong sorry.
I meant instead the the progress bar to be circular, I want it to be more like straight line, little tiny curved not too much.
Thank you.
Just make it a half circle and flatten the curve.
unlock the curving (click on the padlock) and make the bottom setting much smaller
Ron
Samsung Developer Relations
I Played with this section al lot , I will give it a try again.
Thank you.