The first, how can I create in the customizations, the possibility of changing the color of the dial theme, background color or indexes and/or other elements?
The second, I have a watch 7 44mm, how can I adapt a progressive bar to the curve of the dial in any position?
For example, if I want to put it in the center at the bottom as in the attached photo, how can I adapt its size and curvature so that they are like those of the lower central part of the dial?
I tried to increase/decrease the size, change the inclination, but it always comes out different compared to the shape/curve of the dial.
First I would pick the progress bar to be a quarter and set the curving to something like 430 x 430. That should bring it near the edge with the proper curving.
Then make sure the pivot is set to 225 x 225 to center it. To get it in the right position change the angle to -45 in this example to center it.
Thanks. I have a question about this too. I want a curved bar thats work to the other direction. Not clockside. There is a option to select the direction of the curved bar. But this don t fit with the circle.
I want it on the right side from 6 to 3.
Any idea or is it a bug i don t get it. Thanks.
Thanks for your help. The problem is if the range is from 6 to 3 its ok but if you want the same range as the yellow one the curve from the blue dont fit to the circle. If you can help me you make me verry happy. Thanks
Follow the sequence I attached above.
first after the change from full circle to quarter, move it so that the center of screen matches with center of the arc. Only then start adjusting the curving to match the outer radius.
If the bars have to maintain constant distance around their whole length, then they have to be what is called “concentric” = they need to have same center point.
That s the point it doesn t work.If i put it like you the corner in the middle the length of the blue is from 3-6. I want it in the same proportion as the yellow. I marked it.The yellow one is clockwiise direction. The blue one is the counterclockwise.
No bug at all. Sorry I did not notice the black gaps between the arcs in your example and at first you did not mention that you want it to go only from nearly 6 to nearly 3. That means, those arcs in example are not using whole quarter of circle circumference, so to match them you would have to set the progress bar size manually, those premade templates wont fit in this case, but could be good for quick work otherwise.
We will have to use less than 1/4 of the whole circle (90°), lets say only 70° and start at the bottom, one half of the difference (10°) from the axis, to make it look symmetrically offset from the axes.
