Hello, dear everyone!
I want to tap and change the watch face image.
What should I do on WFS?
Thanks.
Hello,
0.Put in the first image
1.turn on action on it, set it to tap and image change
2.add image (images) of your changed design
3. tap the face - the first image changes to the next image. tap to cycle.
2 Likes
Thanks to you, it works!
I know it is an old topic and I managed to do it on my Tizen . But I can not see any difference between the two shots bar the preview. I can not see where the second image is . I have a face built I just want to lay a Grey blank over the top to make a Torchy .
Hello Russel, add a transparent image first, that will cover the flashing area. Then make it changeable by tap and add light opaque image as alternative (point 2 above).
1 Like
OK . Thanks for getting back my friend . Sadly these days I remember little .
So after a while you begin to think you will not get it . Then you meet someone like @Peter and begin to realise it is possible . Because I had made the Face already I needed something I could put on the top layer . The secret was a transparent Image . I noticed I could not alter the Opacity of just one of the Images in my Media Change . I will post the resource here but People might not see it . It is there under my Screen shot .
So the first layer is the Transparent one second a full white square . Thanks again Peter .
Sadly we seem to have lost double tap . Progress :::)))
