Hi everyone,
I hope this guide can help you, it has always worked for me on Windows PC.
- On the Smart Watch
- Settings.
- About Watch.
- Software
- In Software Version Touch 5 times repeatedly until it says Developer Mode Turned On.
- Touch the top button of the Smart Watch to return to the About Watch page.
- On the About Watch page scroll to the bottom, you should see something that says Debagging is Turned Off / On.
- Leave pressed the power button until it says Galaxy Watch Rebooting.
- When the device restarts go to the Settings.
- Connections.
-
Wi-Fi.
10-1. (Wi-Fi and Wi-Fi Networks will appear) - touch where it says Wi-Fi and select Always on
12- Then touch where it says Wi-Fi Networks and connect to the same Wi-Fi network of the PC / Laptop.
11- When connected to the same Wi-Fi Networks, touch the name of the Wi-Fi and copy the IP Address on a piece of paper.
- PC/Laptop
- Download Tizen Studio.
- Install Tizen Studio.
- Open Tizen Studio.
- At the top tap Divice Manager As shown in the image.
- When it opens, touch where it says Remote Device Manager as shown in the photo.
- Touch where it says Add Device as shown in the photo.
- In the panel that will open, insert the IP of the Smart Watch that you copied on a piece of paper, then add a name that you like the most and touch add, as in the photo.
- then touch ON / OFF and Close as shown in the photo.
- It should appear as in this photo, then minimize Device Manager and Tizen Studio.
- Open Galaxy Watch Studio.
- Open any Project.
- When the project opens, touch F9 or Run on Device as shown in the image.
- It should automatically appear to you, as shown in the photo.
Note: After doing all these steps the Smart Watch should appear, if it appears, if so you can close Tizen Studio and Device Manager.
Regards
Robert